Concrete Products

Quikrete Concrete Mix

Pre-blend of Portland Cement, Sand, and Gravel. Just add water. Used for general concrete work. Yields approx .60 cu ft/80 lb.

Lafarge Grey Portland Cement

Consistent plastic and hardened mortar properties. Mixes well with hydrated lime. 90 lb.

Lafarge/ Federal White Portland Cement

Consistent plastic and hardened mortar properties. Mixes well with hydrated lime. 90lb

C-Cure Thin-set Full-Contact 907

Pre-blended polymer-modified dry-set mortar. Specially formulated to fully support heavy tiles and natural stone, gauged or ungauged. Can be built up to ¾” without shrinkage. Can hold large stone in place in demanding vertical applications. Interior or exterior. 50 lb.

Spec-Mix Masonry Mortar Mix Type N

Pre-blend of Portland Cement, Hydrated Lime and dried Masonry Sand. Type N is a medium compressive-strength (750 psi) mortar made of 1 part portland cement, 1 part hydrated lime and 6 parts sand. Type N is recommended for most exterior, above-grade walls exposed to severe weather, including chimneys, outdoor fireplaces, and walls. 80 lb.

Spec-Mix Masonry Mortar Mix Type S

Pre-blend of Portland Cement, Hydrated Lime and dried Masonry Sand. Type S is sometimes specified for masonry at or below grade, but offers another quality. S has high compressive strength (1800 psi) but adds high tensile bond strength. S contains 2 parts portland cement, 1 part hydrated lime and 9 parts sand, and yields maximum flexural strength to fight wind, soil pressure or earthquakes. 80 lb.

Brixment Mortar Mix Type N

Pre-blend of Portland Cement and ground limestone. Should be mixed with 2 ¼ to 3 cubic feet of masonry sand Right Bond Bonding Admixture 1 gal/ 5gal – significantly improves adhesion, tensile, compressive and flexural strengths of cement based materials. Improves freeze-thaw stability of cement based products. May be used above or below grade, interior or exterior. 70 lb.

Spec Mix Polymer Modified Stone Veneer Mortar (PMSVM)

  

Pre-blend of dry cementitious materials, masonry sand and performance polymers specifically designed to provide superior bond for natural veneer and bricks. PMSVM is a technically advanced mortar deigned to provide excellent workability, cohesion, high bond strength , water resistance, efflorescence minimization and durability. PMSVM is an ideal solution for architects and contractors where high bond strength and sag resistance mortar is needed during installation. 80 lb.


The Company We Keep

The company you keep says a lot about you...there are 6,000 reasons you're making a good choice with Lurvey! Read More >

Our Affiliates